How to process spiral chutes

How to process spiral chutes

How to process spiral chutes? Firstly, it illustrates that gravity beneficiation is widely used in the beneficiation of metal or non-ferrous metals due to its low pollution and cost. The spiral concentrator is one of the gravity separation machines, characterized by a cubic parabola shaped cross-section, suitable for processing finer particle sizes of -0.2 millimeters. In the sorting process, no flushing water is required, and the tailings are obtained by dividing them into sections at the tail end of the tank. 2、 Production principle: The spiral chute mineral separator does not need to be restricted from being stacked on the cross (or tripod) of the support table. The evenly proportioned mortar is slowly fed onto the surface of the spiral groove through the feeding groove installed at the end of the rotating groove head for selection. The tail is equipped with a valve type equipment selection tank, which divides the sorted products into three types (or four categories) according to grade along the radial direction. Change the cutting width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that allows for the dense export of the obtained variable mineral flow differentiation. The transverse plane of the fiberglass spiral chute has different slopes, which is very suitable for the separation of fine mineral particles. How to process spiral chutes 3. Characteristics 1. Stable and easy to control the sorting process 2. Large allowable range of feed density 3. High enrichment ratio and high recycling rate 4. Small land occupation and low water consumption 5. Simple structure, no power required 6. Large processing capacity 7. Easy installation and simple operation 8. Small investment, quick results. How to process spiral chutes 4. Classification according to the size of mineral materials processed, Chutes can be divided into three types: (1) coarse grained spiral chutes, with a maximum particle size of 2-3mm or more for ore feeding, and a maximum of 100-200mm. (2) Sand ore chute, processing 2-3MM particle grade ore. (3) Slurry spiral chute, feeding Granularity<0.074mm. 5、 The application range of fiberglass spiral chute is suitable for processing 0.6-0.03MM and this vein ore and mineral, but it is unfavorable for separation when the mud content is high. Nowadays, it is widely used for processing iron ore, tungsten, tin ore sand, niobium tantalum ore, coastal and riverside placer mines, and sand gold mines. How to Process Spiral Chutes How to Process Spiral Chutes

How to process spiral chutes

How to process spiral chutesRelated Information

• 

  Grooved spiral chute

• 

  Fiberglass spiral chute

• 

  Automatic ore discharge centrifugal conc

• 

  Shaftless drum screen